Australia Update

All information about Australia

Automative

Simple Tips For Repairing Your Car’s Fibreglass Bumper

You should do Sydney bumper repairs immediately you notice damage on your bumper. Fibreglass bumpers are safety devices that protect the car from damage. They do this by absorbing impacts and shocks so it may be necessary to repair your car bumpers once in a while. The repair process is straight forward and repairing your bumper at home can help you save a lot of money.
 
Remove the bumper

If you are removing the front bumper, you should disable the airbag. Remove any nuts, screws and clips that hold the bumper in place. Slide the fibreglass bumper off the car.

Cleaning the bumper

Before repairing the bumper in Australia, it is essential to clean it first. Grind down the raised surface of the bumper along large cracks. Sand down the raised surface of the bumper along small cracks. Use acetone to scrub the fibreglass surface.

Fixing the bumper

When doing bumper repairs Sydney in Australia, you should buy hardener, resin, and cloth matting strips. Cut the matting of the fibreglass to the size of each cracked area. Mix the hardener and resin together. Use the resin mix to apply the matting to your bumper.

Final touches

Once the fibreglass is fully cured, you will need to sand down the fixed areas of the bumper using 600 grit dry and wet sandpaper. This should be done on both sides of the bumper until the patches of the fibreglass are smooth to touch. Do not use a handheld grinder to avoid breaking the new seals.

Cover the fixed areas with a filler if necessary. Sand down the entire fibreglass bumper. After finishing Sydney bumper repairs in Australia, you can repaint the bumper if you want. Reattach the bumper by sliding it onto your car. Replace bumper fasteners and tighten them. If necessary, reconnect the airbag and you will be through with your repair.

6 COMMENTS

LEAVE A RESPONSE

Your email address will not be published. Required fields are marked *